There is a worklight under the hood of of the 88 cherokee. It is mounted to a bracket and is retractable like a tape measure. The wire that is in it is long enough to reach the back of the vehicle and fix a a flat in the dark. On my Jeep the line was about a third pulled out and wrapped around the mount. I decided I would take it off and see if I couldn't fix it. Well turns out I could. All I did was pour a little 3-in-1 oil into the hole the wire retracts into and work it back and forth a bit and it was working like a champ. While I was allowing the oil to seep around the internal mechanism I decided to sand and paint the bracket. I just took some 150 grit sandpaper and got all the rust off, washed it down with a degreaser, and painted it with the same red I used on the drums and calipers. It came out looking much better than the original black. I even painted the bolts to pretty it up a bit.
The whole thing took me about an hour and that was because I was just poking around. I had to call my wife down to look because I was kinda proud of the job I did "fixing" the light. It was essentially free since I used leftover stuff from other jobs and it was pretty cool and I have a usable light now.

No comments:
Post a Comment
Leave a comment if you wish. I appreciate all suggestions and technical advice as well.