Custom Search

Wednesday, June 03, 2009

Pocket Fisherman


I thought I would go off topic for a minute and throw a good idea out there for the outdoor enthusiast. I have been making some para cord key chains and knife lanyards and decided to add a piece of copper to snazz them up a bit. While at the work bench I was brainstorming about ways to use these scraps of copper pipe that I had on the key chains when I came up with a pretty good idea. Inside this 2.25 inch piece of copper is 15' of 6lb test fishing line, 6 sinkers, a swivel, and 2 hooks. You can even use the top as additional weight or as a make shift lure. It is small enough to be a key chain too. You could also put a couple match sticks in there I just don't have any. It is also solder free. I used super glue to keep the bottom cap on. If I had a tap and die set I would have made it so you could screw the top on and then weld a "D" hook to the cap. The it would be more water tight not completely but more. Run the line through the holes on the sides and you have an anchor to wedge into the dirt. It was cheap, fast, and cool enough to boast about. Go make your own today!!!

No comments:

Post a Comment

Leave a comment if you wish. I appreciate all suggestions and technical advice as well.